05-22-2007, 03:30 PM
|
#2
|
|
Free Rides On A Silverback
SAXON117 is offline
Join Date: Apr 2006
Location: Highpoint Mountain, NJ
Posts: 2,601
|
Quote:
Originally Posted by NYCSTRIPES
Well, knew this type of thing was coming eventually. I had to pull the motor on the TZ250 and replace the crank. I was half way through the top end and I found a bent connecting rod. That turned into dropping the motor and pulling the crank shaft out for replacement. Then I will re-do the top end like I had originally planned...Good thing I had a new crank ready to go. Half way there, pulled the crank, have the replacement on the ready, cleaned up the cases and getting ready to apply sealant and re-assemble.
Wish me luck, first time re-build.
Ken
|
post up some pix of the project.
__________________
ATTACK LIFE, ITS GOING TO KILL YOU ANYWAY
10-08-07 R.I.P. 109  
12-06-07 R.I.P. Jack
|
|
|
|