swingarm tool for suzukis
I was just wondering if anyone in the area had one I could borrow, before I take a dremmel to a 32 mm socket. I need one to get the swingarm off my TL. Then I will also see what I will need to get the triple tree off. Then I can fianlly get the stuff to the powder coater and start reassembly:ride:
Tom |
Why not just go buy the tool?
|
buy a cheap socket and grind it. I did that when building my 1K. It works and is much cheaper.
|
The tool is like 60 bucks, ant...
Tommy... i think the torque spec on that thing is like 10ft/lbs, i just parted out my TLR... took a punch and a hammer, it was free in the 1st whack... its the easiest solution... |
I just changed the pivots to +1mm (from +2mm) and remember going through the manual to get the torque settings...
The swingarm pivot shaft is 11ft/lbs, but the pivot nut is 72.5ft/lbs and the lock nut is 65ft/lbs. My swingarm tool is just a modified socket. Works like a charm. :) |
Quote:
Tom |
just use a bigger hammer!
|
|
Well I sacrificed a 32mm socket and it came off in a snap. Went through 2 and a half cutting wheels cutting the sections off. Now I just need to get the triple tree off and its off to the powdercoater:ride:
Tom |
Nice Tommy....and sorry to hear about your socket :lol:
|
Quote:
GF thinks shes getting money to buy sandals boy is she mistaken:doh: Tom |
All times are GMT -4. The time now is 01:08 AM. |
Powered by vBulletin® Version 3.8.2
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.