Now that’s a Highmount

[BurnCycle]

It’s done… My TLS is officially back to being a 2-2. The 2-1 system will go on my TLR sometime later. The 2-2 is definingatly (haha) louder than the 2-1. I can’t comment on power differences due to it being to damn cold out but during the short ride I did take the devilish grin was bigger than had been for a while.

BTW… for those that don’t know this is the back end of a TLR system on the S.

But on with the show… with a dirty bike…
http://www.mariposaderojo.com/Pics/TLS/14Jan06/FrontFull2.jpg

Highness…
http://www.mariposaderojo.com/Pics/TLS/14Jan06/BackEnd3.jpg

BooYA
http://www.mariposaderojo.com/Pics/TLS/14Jan06/BackEnd4.jpg

Asymmetrical hangers…
http://www.mariposaderojo.com/Pics/TLS/14Jan06/Undertail1.jpg

Since things are asymmetrical I had to fabricate new hangers. As you can see they are ver different from left to right.
http://www.mariposaderojo.com/Pics/TLS/14Jan06/LHanger1.jpg
http://www.mariposaderojo.com/Pics/TLS/14Jan06/RHanger1.jpg

I did a quick polish job on the front pipe… Over time no one will be able to see the mismatch.
http://www.mariposaderojo.com/Pics/TLS/14Jan06/FrontPipe1.jpg

Parting shot…
http://www.mariposaderojo.com/Pics/TLS/14Jan06/FrontFull3.jpg

[CBRBob]

You're a flamer......... LOL

[Kurts1000RR]

Nice!

[High_Revs_17]

You mean "highrise" ;) , but it looks great all the same. :sweat:

BTW, I don't wanna hear you bitching about the cold, it's 20 degrees here and snow is back on the ground. :rolleyes:

[carl_g]

You mean "highrise" ;) , but it looks great all the same. :sweat:

BTW, I don't wanna hear you bitching about the cold, it's 20 degrees here and snow is back on the ground. :rolleyes:
WTF is a high rise?
I don't see any buildings ion the background :wtf:

Looks good BC!

[High_Revs_17]

WTF is a high rise?

High-rise (his pics) is when the mid-pipe exits low and then gradually rises up to the mounting point of the can. The can is not parallel with the lower lines of the tail.

High-mount is when the mid-pipe exits high at sharp degrees then levels out so the can is parallel to the lower line of the tail section.
http://www.revlimiterracing.com/Merchant2/graphics/00000001/devilzx6sb2.jpg

I've seen the RC51 run both styles...

[Vin]

Tits, as Bern's bikes usually are. Very nice.

[BurnCycle]

You mean "highrise" ;) , but it looks great all the same. :sweat:

BTW, I don't wanna hear you bitching about the cold, it's 20 degrees here and snow is back on the ground. :rolleyes:

You say toMAto, I say toMARto...

It's a bit of both. Buy just looks one could say a high-rise or high-exit due to the angle of the pipes. But it does also clasify and is marketed as a highmount due to the longer mid pipes raising the location of the mount of the pipe.

Hey it was only 12° warmer here... but no snow. :lol:

[motopix]

Nice cans.

[FigNewTon]

Very :pimp: